IMPORTANT MANUAL -- Do not throw awayMANUAL IMPORTANTE -- No lo descarteMANUEL IMPORTANT -- À ConserverRSM210VSENGLISHESPAÑOLFRANÇAISWARNING:Read and
-- 1 0 --S Wipe off unit with a clean dry cloth.CLEAN AIR FILTERA dirty air filter decreases engine perform-ance and increases fuel consumption andhar
-- 11 --To adjust idle speed:Allow engine to idle. Adjust speed until engineruns without stalling (idle speed too slow).S Turn idle speed screw clockw
-- 1 2 --TROUBLECAUSE REMEDYEngine will notstart.1. Engine flooded.2. Fuel tank empty.3. Spark plug not firing.4. Fuel not reachingcarburetor.5. Compr
-- 1 3 --LIMITED WARRANTYPoulan PRO, a division of Husqvarna Consum-er Outdoor Products N.A., Inc., warrants to theoriginal consumer purchaser that ea
-- 1 4 --abuse, neglect, improper maintenance, un-approved modifications, or the use of partsnot made or approved by the original equip-ment manufactu
-- 2 --IDENTIFICATION OF SAFETY SYMBOLSWARNING: This unit can be dangerous! Careless or improperuse can cause serious injury.Read your operator’s manu
-- 3 --IDENTIFICATION OF SAFETY SYMBOLSWARNING: Fire hazard. Never mix, pour, or store gasoline oruse the unit near a flame or sparks (including smoki
-- 4 --D Move at least 10 feet (3 meters) away fromfuel and fueling site before starting engine.D Always store gasoline in a container ap-proved for f
-- 5 --ASSEMBLYWARNING: Stop engine and be surethe impeller blades have stopped turning be-fore opening the vacuum inlet door or at-tempting to insert
-- 6 --1. Insert the tip of a screwdriver into the latcharea of the vacuum inlet.LatchAreaBlowerOutletVacuum Inlet CoverLatch Area2. Gently tilt the h
-- 7 --OPERATIONKNOW YOUR BLOWERREAD THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERA TING YOUR UNIT.Compare the illustrations with your unit to
-- 8 --S To reduce noise levels, operate powerblowers at the lowest possible throttlespeed to do the job.S Use rakes and brooms to loosen debris be-fo
-- 9 --ThrottlePositionLever(CruiseControl)2. Slowly press the primer bulb 6 times.3. Move the start lever to the ST ART position.StartLeverStarterHan
Komentáře k této Příručce