Poulan 96192000600 Uživatelský manuál

OWNER'S MANUALMODEL NUMBER:PP930ESSNOW THROWER Always Wear Eye Protection During OperationIMPORTANT MANUAL Do No

10TO CONTROL SNOW DISCHARGE (See Fig. 14)WARNING: Snow throwers have ex- posed rotating parts, which can cause severe injury from contact, or from ma-

11OPERATIONTO THROW SNOW (See Fig. 15)The auger rotation is controlled by the auger control lever located on the right side handle.• Squeeze auger

12TO ADJUST SKID PLATES (See Fig. 19)NOTE: The wrench provided in your parts bag may be used to adjust the skid plates.Skid plates are located on each

13OPERATIONCOLD START - ELECTRIC STARTER1. Insert safety ignition key into the ignition slot until it clicks. DO NOT turn the key. Keep the extra

14GENERAL REC OM MEN DA TIONSThe warranty on this snow thrower does not cover items that have been sub ject ed to operator abuse or negligence. To re

15MAINTENANCEAUGER GEAR CASE• The gear case was fi lled with lubricant to the proper level at the factory. The only time the lubricant needs attent

16CAUTION: Do not substitute. Use only original equip ment capscrew/shear bolts as sup plied with your snow thrower.4. Connect spark plug wire to sp

17BELT KEEPERIDLER ARM SQUARE HOLEBOLTLOCK WASHERTRACTION DRIVE BELTCLUTCHING IDLER ARM BRACKETAUGER BELTFLAT WASHERAUGER PULLEYAUGERHOUSINGFRAMEENGIN

18SERVICE AND ADJUSTMENTSSTORAGEImmediately prepare your unit for storage at the end of the season or if the unit will not be used for 30 days or more

19Does not start 1. Fuel shut-off valve (if so 1. Turn fuel shut-off valve to OPEN position.

2IMPORTANTSafe Operation Practices for Walk-Behind Snow ThrowersThis snow thrower is capable of amputating hands and feet and throwing objects.Failure

LIMITED WARRANTYThe Manufacturer warrants to the original consumer purchaser that this product as manufactured is free from defects in materials and w

3PRODUCT SPECIFICATIONSGasoline Capacity 4.0 Quartsand Type: Unleaded Regular onlyOil Type SAE 30 (above 40°F)(API SG–

4PARTS PACKED SEPARATELY IN CARTON

5Read these instructions and this manual in its entirety before you attempt to assemble or operate your new snow thrower. Reading the entire manual w

6ASSEMBLY / PRE-OPERATIONINSTALL SPEED CONTROL ROD (See Figs. 1 and 2)1. Remove plastic tie securing rod to lower handle.2. Insert rod into speed

7ASSEMBLY / PRE-OPERATION1. Slide rubber sleeve up rod and hook end of spring into control arm with loop opening up as shown.2. With top end o

8OPERATIONKNOW YOUR SNOW THROWERREAD THIS OWNER'S MANUAL AND ALL SAFETY RULES BEFORE OPERATING YOUR SNOW THROWER. Compare the illustrations with

9OPERATIONThrottle/engine control - used to se lect either FAST or SLOW engine speed and to STOP the engine.Traction drive control lever - used to eng